Call For Admission - 9644139972

Advance Mobile Repairing Free guide Solution & Software

Saturday, 11 November 2017

How to Solve Samsung Galaxy Note 3 Charging solution with jumper picture




How to Solve Samsung Galaxy Note 3 Charging Solution  with Jumper Picture



By far, one of the worst problems noted in Samsung Galaxy Note 3 is its charging problem, and this is mainly because if your charging connector is giving you problems then sooner or later your phone is going to be out of charge hence rendering you completely helpless, therefore it is highly recommended that one should get it fixed as soon as one notices any such charging issues.
In the following lines you will get to know about some of the charging problems related to Note 3 along with their solution.

Problems

  • Note3 is not charging at all.
  • Phone charges really very slow.
  • Galaxy Note 3 heats up during charging.
  • Phone does not give any response when charger is connected.

Reasons of Problems

  • Phone could be water damaged.
  • Dust particles might be present in charging connector.
  • Your Note3 charger might be faulty.
  • Connection in the phone might be broken.
  • Phone is encountered any physical damage.
  • Any of the capacitors might be faulty.
  • Charging IC might be faulty.


प्रॉब्लम 

  • डुप्लीकेट चार्जर यूज़ करने के कारण 
  • मोबाइल हीट करने के कारण 
  • पानी जाने के कारण चार्जर सप्लाई ख़राब हो जाना 

Workaround






Hardware Solution



सलूशन : 

  1. सबसे पहेले मोबाइल फ़ोन को खोले | मोबाइल फ़ोन की पीसीबी को बहार निकाले | 
  2. थिनर  ( क्लीनर ) से मोबाइल फ़ोन को वश करे | 
  3. मोबाइल फ़ोन में चार्जर केबल लगा कर चार्जर कनेक्टर की आउटपुट सप्लाई चेक करे  | 
  4. चार्जर से चार्जर कनेक्टर के  vcharge वाली पिन पर 5 से 6 DC मिलना चाहिए | 
  5. यदि चार्जर से आउटपुट वोल्टेज मिल रहा है तो चार्जर कनेक्टर बिलकुल सही है | 




  • चार्जर कनेक्टर से बैटरी कनेक्टर की बीच की सप्लाई चेक करेंगे  | 
  •  VCharge  supply  में लगे कएल  को चेक करे   |

  • Now check connection between 1st pin of the charging connector and Capacitor – 1. In case Capacitor – 1 is faulty, replace it.



  • The next thing that you need to do is to check connector of charging dock, clean the charging dock. If it is still faulty even after cleaning then change the entire charging dock.
  • Now check on-board connector, clean and re-solder it.






  • Now check Capacitor – 2, Capacitor – 3 and Coil 1, if any of them is faulty replace.
  • Now finally check Charging IC, gently heat it and check. If heating doesn’t do any good then replace Charging IC and check.



Copyright by Asia Telecom ,Created By Asia Telecom. Powered by Blogger.