Call For Admission - 9644139972

Advance Mobile Repairing Hardware & Software Complete Guide

Friday, 22 June 2018

How to Put iDevice in DFU Mode, Recovery Mode and Normal Mode?

How to Put iDevice in DFU Mode, Recovery Mode and Normal Mode?





iDevice has three mode, normal mode, recovery mode and DFU mode. but what can we do with iDevices in these three modes? How to put them in DFU mode, recovery mode and normal mode?

In general, it is required to know how to enter/exit these three modes when you flash, restore and downgrade your iDevices using 3uTools. Now, this tutorial is for you to know what to do when you begin iOS jailbreaking, flashing and restoring.


1.Normal mode

Keep the iDevice in normal operating, and connect your iDevice to the computer via the USB cable. Start 3uTools, and then the device is in normal mode as following screenshot:



  2. Recovery mode 


There are two ways to enter recovery mode.
1. Enter recovery mode manually.
  • Ensure you connect your iDevice to 3uTools.
  • Turn off the iDevice.
  • Press the Power button, and the white Apple logo will appear on the screen.
  • Don't release the Power button, and then hold the Home button till the screen become blank.
  • Please release the Power button as the screen become blank, but don’t let go Home button. The device enters recovery mode when 3uTools detects an iOS device in recovery mode


2. Enter recovery mode using 3uTools






How to exit recovery mode
  • Ensure 3uTools has detected an iDevice in recovery mode.
  • Hold “Home+Power” at the same time, till the white Apple logo appears on the screen. It means that the iOS device has exited the recovery mode, and is rebooting.


Or you could exit recovery mode using 3uTools. 


3. DFU mode




How to enter DFU mode
For iPhone 6s or earlier or iPad: Firstly hold the Home button, and then the Power button. Continue holding them for about 4 seconds after the screenbecome blank, and then release the Power button. Keep holding the Home button till 3uTools detects an iOS device in DFU mode.

For iPhone 7 or 7 Plus: 
1. Open 3uTools and connect your device with your PC. 
2. Turn off your iDevice by long-pressing Power Button.
3. Long-press the Power Button for about 3 seconds, then press Volume Down Button. Note that you need to still hold down Power Button.
4. Now keep holding both of the buttons for about 10 seconds. It is to be noted here that if Apple logo appears on the screen, you will have to start it again.
5. Release Power Button and keep pressing Volume Down Button for around 5 seconds.
6. This might bring you on a screen where it is written “Plug into iTunes”, and 3uTools will display that the device is in DFU mode. Make sure not to hold it for too long.

For iPhone 8/8 Plus, or iPhone X: 
Firstly, you need to turn off your iPhone. Hold the Power button for 3 seconds, don’t let it go. And then press the Volume Down button for 10 seconds. Next release only Power button, and continue holding Volume Down button, then iDevice’s screen will become black, keep holding the Volume Down button till 3uTools detects an iOS device in DFU mode.

How to exit the DFU mode 
For iPhone 6s or earlier or iPadHold “Home+Power” till the Apple logo comes out on the screen, and then the device can exit the DFU mode.

For iPhone 7 or 7 Plus: Long-press Power Button and one of the Volume Down Button till Apple logo appears on the screen.

For iPhone 8/8 Plus, or iPhone X: Press and release the Volume Up button, press and release the Volume Down button, and press and hold the Side button until you see the Apple logo appear on screen.

Copyright by Asia Telecom ,Created By Asia Telecom. Powered by Blogger.